Add Displayed Sensors Checkbox

[ffpresto]

We have two Active 2 systems. On one, the "Add Displayed Sensors" box is not checked when a new file is started. On the other, this box is checked. We would like to have it unchecked (since it is much too easy to forget to uncheck the box), but I am not sure how to accomplish this. Can anyone help me out?

Thanks,
.. Frank

[Coen]

Check the box, save a short BDF file (not needed to connect any electrodes, a few seconds is enough), and save the new settings in a CFG file (available on the "about" tabpage).

In general, you can save all setting of the front panel controls in CFG files. ActiView starts with loading the default.cfg file, you can load different CFG files for different experiments.

Best regards, Coen (BioSemi)