Add Displayed Sensors Checkbox

Post Reply
Posts: 3
Joined: Thu Oct 08, 2009 5:37 pm
Location: University of Waterloo

Add Displayed Sensors Checkbox

Post by ffpresto » Wed Jul 18, 2012 8:13 pm

We have two Active 2 systems. On one, the "Add Displayed Sensors" box is not checked when a new file is started. On the other, this box is checked. We would like to have it unchecked (since it is much too easy to forget to uncheck the box), but I am not sure how to accomplish this. Can anyone help me out?

.. Frank

Site Admin
Posts: 984
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands

Re: Add Displayed Sensors Checkbox

Post by Coen » Thu Jul 19, 2012 2:39 pm

Check the box, save a short BDF file (not needed to connect any electrodes, a few seconds is enough), and save the new settings in a CFG file (available on the "about" tabpage).

In general, you can save all setting of the front panel controls in CFG files. ActiView starts with loading the default.cfg file, you can load different CFG files for different experiments.

Best regards, Coen (BioSemi)

Post Reply