Yet another aquisition software
Posted: Thu Oct 18, 2012 3:47 pm
Hi all,
i successfully receive the data from ActiView via TCP/IP. The values match with the values in the ActiView Electrode Offset tab. What I can't explain myself is the reaction to changes.
My setup is:
- All electrodes in a glass of water
- start aquisition
-> everything is fine
If I remove one electrode from the glass the offset in ActiView goes up to 259.xxx, my aquisition software keeps its old value (+some uV noise, on all channels ).
If I restart my software the value goes up to 259.xxx .
Is there any obvious explanation for this behaviour that I am missing?
Thanks for any hints
Vincent
i successfully receive the data from ActiView via TCP/IP. The values match with the values in the ActiView Electrode Offset tab. What I can't explain myself is the reaction to changes.
My setup is:
- All electrodes in a glass of water
- start aquisition
-> everything is fine
If I remove one electrode from the glass the offset in ActiView goes up to 259.xxx, my aquisition software keeps its old value (+some uV noise, on all channels ).
If I restart my software the value goes up to 259.xxx .
Is there any obvious explanation for this behaviour that I am missing?
Thanks for any hints
Vincent