BioSemi.nl

Dear all,
I have a question re: biosemi acquisition. In some blocks...while recording data and acquiring with Biosemi, it suddenly turns off the saving button..., I don't know why, and I have to turn it on again. I don't know why it does this. Has this even happened to any of you? Do you know how can I stop it? I just would like it to record until it finishes the block or until I want to stop it myself.
Thank you so much,
s

Is the saving paused, or really stopped ? If just the pause button is operated automatically, then your CFG is probably configured to let the pause button react on a certain trigger code. Corrrect this by entering PauseOff=-1 and PauseOn=-1 in the CFG.

Best regards, Coen (BioSemi)

Okay thank you, I will try that and I will let you know.
Thank you very much,
s