BioSemi.nl

Hi,

This may be a daft question and apologies if it has been answered before - I am afraid I do not have much experience with ActiveView/Biosemi.
The PC that has Active View installed in (and Biosemi set up with) needs to be retired - it's a W7 machine.
This will be replaced by a W10 machine in which I will install the software and hopefully setup Biosemi successfully.

My question is if there is anything I need to bear in mind for this operation for instance do I need to "deactivate" the software/license first from the current machine before I install it to the new machine, any issues with W10 I need to be aware of, etc?

Again apologies if this has been asked/answered before

Make sure that the firmware of the USB-receiver is upgraded before connecting to the W10 computer, see https://www.biosemi.com/faq/install_USB.htm . No need to install drivers on the W10 machine.

Download ActiView 9.02 and LabVIEW RTE 2021 from https://www.biosemi.com/download.htm . There is nothing to license or deactivate.

Best regards, Coen (BioSemi)

So many thanks Coen for the swift reply and the steps I need to follow, much appreciated.