response box output triggers

Post Reply
Dorothee
Posts: 1
Joined: Wed May 20, 2015 10:10 am

response box output triggers

Post by Dorothee » Wed May 20, 2015 10:38 am

Hi,

A new feature of Actiview Version 7.0 was "Response switches can now generate Triggers outputs on USB receiver. (in order to sent signals to stimulation software)". Is there any modification to make in the cfg file for this to happen, apart from setting <RespSwitch> from 0 to 1 ? Then, which output lines will contain the response box triggers ?

Thanks in advance for any information about this.


Dorothee

Coen
Site Admin
Posts: 980
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: response box output triggers

Post by Coen » Wed May 20, 2015 2:33 pm

RespSwitch on 1 (ERGO input) or 2 (SWITCH input).

Switch action will operate output triggers on pin 17 and 19 (output triggers 1 and 2), no further modifications needed.

Best regards, Coen (BioSemi)

Post Reply