Page 1 of 1
Saving bipolar channels
Posted: Tue Feb 26, 2013 12:20 pm
by obonsawin
I may be missing something obvious here. I have started recording EMG, and can view the relevant bipolar channels on the bipolar tab. Unfortunately, I can't figure out how to save these bipolar channels. I only seem to be able to save the monopolar channels EX channels. I am sure I am not seeing something obvious on the Actiview screen. What am I missing?
Thank you
Marc
Re: Saving bipolar channels
Posted: Tue Feb 26, 2013 1:01 pm
by Coen
There are no separate bipolar hardware channels. The bipolar display is simple a referenced view of the EX channels. If you save the EX channels, then all is OK. You should of course calculate the bipolar leads again in you off-line review software (EX channel are saved in unreferenced monopolar form)
Best regards, Coen (BioSemi)
Re: Saving bipolar channels
Posted: Tue Feb 26, 2013 1:27 pm
by obonsawin
Thank you Coen.
Marc