Response trigger

Post Reply
Asuka
Posts: 3
Joined: Thu Jul 23, 2009 6:03 am
Location: Michigan

Response trigger

Post by Asuka »

Hi,
I'm new to BioSemi system and have a question about triggering. Please forgive me if I'm asking about something obvious.
We have no problem with inputting stimulus trigger signals, but we want to use response trigger signals. Can ActiVew accept them and discriminate between stimulus and response signals?

Thank you for any help!
Asuka

Coen
Site Admin
Posts: 1124
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Post by Coen »

On the trigger port, 16 input lines are available (see http://www.biosemi.com/faq/trigger_signals.htm). Many researchers use triggers 1-8 for stimuli, and triggers 9-16 for responses. ActiView supports this use by offering trigger display modes (decimal, binary and custom) that show the triggers in two separate groups (each an 8-bit result).

Best regards, Coen (BioSemi)

Asuka
Posts: 3
Joined: Thu Jul 23, 2009 6:03 am
Location: Michigan

Thanks!

Post by Asuka »

Hi Coen,

Thank you so much!

Asuka

Post Reply