Trigger code not shown

Post Reply
RaphaelXI
Posts: 2
Joined: Fri Mar 24, 2023 4:57 pm

Trigger code not shown

Post by RaphaelXI »

Hello, everyone,

I'm using biosemi to record EEG in my experiment. The triggers were shown at the exact timing but there was no trigger code. They were shown as small lines (cf. image below).

I''m using Presentation to present stimuli and the logfile said that all the stimuli and trigger codes have been correctly sent.

Does anyone have idea about why the trigger codes didn't show ?

Thank you in advance.
Attachments
Trigger codes shown as small lines
Trigger codes shown as small lines
1.png (85.74 KiB) Viewed 2278 times

Coen
Site Admin
Posts: 1124
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: Trigger code not shown

Post by Coen »

About/Configure tab --> Trigger Format (lower left corner) --> Decimal

Best regards, Coen (BioSemi)

RaphaelXI
Posts: 2
Joined: Fri Mar 24, 2023 4:57 pm

Re: Trigger code not shown

Post by RaphaelXI »

Hi, Coen,

Thank you very much for your reply.
I can successfully see the port codes in decimal.

Best regards,

Post Reply