Triggering with BioSemi Active 2
Posted: Tue Oct 18, 2016 6:25 pm
Hi, I am new to this system, and have a question about the trigger inputs.
The trigger box sets the input pins to 3.3V when nothing is connected.
As far as I can tell, the only way to change this is by shorting the inout so that the voltage across the pins goes to 0.
I would like to trigger off of the signal from an accelerometer, or really just any signal, is it possible to do this?
Thank You
The trigger box sets the input pins to 3.3V when nothing is connected.
As far as I can tell, the only way to change this is by shorting the inout so that the voltage across the pins goes to 0.
I would like to trigger off of the signal from an accelerometer, or really just any signal, is it possible to do this?
Thank You