BioSemi.nl

I wonder if anybody has advise on how to get stimulus/response triggers generated by e-prime (sent out through a serial port) to the Biosemi EEG digitizing machine.

Is there a scheme available about how to build a connecting cable?

Thanks

Mario Liotti

Reader of Cognitive Neuroscience
Department of Psychiatry
University of Noyttingham
email: mario.liotti@nottingham.ac.uk

The connection of triggers to the ActiveTwo receiver is described on http://www.biosemi.com/faq/trigger_signals.htm

The pin layout of a cable for an interface with E-prime is found on http://www.biosemi.com/faq/presentation.htm

Best regards, Coen (BioSemi)

We found we had to send a zero after sending an eprime trigger or subsequent triggers would sum. Hope this helps.