Merging BDF invalid

Post Reply
Elad
Posts: 2
Joined: Wed May 18, 2016 11:21 am

Merging BDF invalid

Post by Elad » Wed May 18, 2016 11:30 am

Hi,

I'm trying to merge BDF files using merge86 but somehow when I load a BDF file it says that the file length is invalid (attached image).
Looking at the software, I saw that it puts -1 in the file length (attached image).
However, when I try to merge other files it works fine and when I load this file to the Analyzer it doesn't give me an error and the file is being load just fine...

Any suggestions?

Thanks,
Elad
Attachments
merge.png
merge.png (19.89 KiB) Viewed 6515 times
merge2.png
merge2.png (19.55 KiB) Viewed 6515 times

Coen
Site Admin
Posts: 965
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: Merging BDF invalid

Post by Coen » Wed May 18, 2016 1:56 pm

The "-1" file length indicates that the file was not closed properly during recording (crashed or switched-off computer). Use the repair tool (http://www.biosemi.com/download/ToolsFo ... pair86.zip) to repair the file.

Best regards, Coen (BioSemi)

Post Reply