Saving bipolar channels

Post Reply
obonsawin
Posts: 2
Joined: Thu Jul 21, 2011 10:12 am
Location: University of Strathclyde, Glasgow

Saving bipolar channels

Post by obonsawin » Tue Feb 26, 2013 12:20 pm

I may be missing something obvious here. I have started recording EMG, and can view the relevant bipolar channels on the bipolar tab. Unfortunately, I can't figure out how to save these bipolar channels. I only seem to be able to save the monopolar channels EX channels. I am sure I am not seeing something obvious on the Actiview screen. What am I missing?

Thank you
Marc

Coen
Site Admin
Posts: 969
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: Saving bipolar channels

Post by Coen » Tue Feb 26, 2013 1:01 pm

There are no separate bipolar hardware channels. The bipolar display is simple a referenced view of the EX channels. If you save the EX channels, then all is OK. You should of course calculate the bipolar leads again in you off-line review software (EX channel are saved in unreferenced monopolar form)

Best regards, Coen (BioSemi)

obonsawin
Posts: 2
Joined: Thu Jul 21, 2011 10:12 am
Location: University of Strathclyde, Glasgow

Re: Saving bipolar channels

Post by obonsawin » Tue Feb 26, 2013 1:27 pm

Thank you Coen.

Marc

Post Reply