Manually sending a trigger event to actiview

Post Reply
happilylazy
Posts: 20
Joined: Mon Jun 21, 2010 3:27 pm
Location: Karlskrona

Manually sending a trigger event to actiview

Post by happilylazy » Mon Sep 17, 2012 4:18 pm

Hi.

Is there a way of manually sending a trigger event through software/port/socket/dll (running on the same machine as ActiveView) with comment and such.
I am interested if there is a way to save an event marker without going through an BioSemi USB receiver to trigger and event.

//Petar

Coen
Site Admin
Posts: 969
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: Manually sending a trigger event to actiview

Post by Coen » Mon Sep 24, 2012 11:20 am

Use the keyboard function keys F1 through F8 to generate triggers on trigger lines 9-16 (the lines must be pulled low first at the connector by connecting pin 9-16 to pin 37).

Best regards, Coen (BioSemi)

meganyim
Posts: 1
Joined: Tue Mar 05, 2013 7:23 pm

Re: Manually sending a trigger event to actiview

Post by meganyim » Tue Mar 05, 2013 10:23 pm

Hello,
I am very new to the BioSemi system so please forgive me if this is a simple problem. I have a very similar question about sending manual triggers but am unsure what you mean by "trigger lines 9-16 (the lines must be pulled low first at the connector by connecting pin 9-16 to pin 37)". Elaboration on this explanation or directions to a resource would be much appreciated.
Thank you
megan

Coen
Site Admin
Posts: 969
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: Manually sending a trigger event to actiview

Post by Coen » Wed Mar 06, 2013 11:40 am

Read the FAQ ?

Robbie303
Posts: 21
Joined: Mon Nov 03, 2003 10:03 pm
Location: Amsterdam

Re: Manually sending a trigger event to actiview

Post by Robbie303 » Wed Mar 06, 2013 1:41 pm


elsiedawson
Posts: 1
Joined: Wed Sep 04, 2013 10:41 am

Re: Manually sending a trigger event to actiview

Post by elsiedawson » Wed Sep 04, 2013 10:58 am

I too am trying to manually send triggers, and am also unsure what you mean by "trigger lines 9-16 (the lines must be pulled low first at the connector by connecting pin 9-16 to pin 37)"'. I have read the manual, and cannot make sense of that either. Sorry.
I am trying to send triggers whilst using the portable biosemi system, so only have an aquisition laptop. I have tried using the function keys on this computer, nothing happens, I have tried connecting a signal computer and using that to manually send triggers, nothing happens, and it is no longer portable.
Any suggestions? Thank you

Coen
Site Admin
Posts: 969
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: Manually sending a trigger event to actiview

Post by Coen » Wed Sep 04, 2013 11:21 am

Try to understand:

"the lines must be pulled low first at the connector by connecting pin 9-16 to pin 37"

Best regards, Coen (BioSemi)

Post Reply