modify STRIDE value for use with Matlab API
Posted: Thu Nov 01, 2018 8:56 am
Hi all,
I am trying to write a small BCI application in Matlab and I experiened huge delays between the generation of the signals and the atorage after TCP/IP transfer. As far as I understood from posts on this forum (but this may be totally wrong)this due to the value of the STRIDE parameter in the Active View source. Would it be possible to play with this parameter without accessing to Labview?
Best,
LL
I am trying to write a small BCI application in Matlab and I experiened huge delays between the generation of the signals and the atorage after TCP/IP transfer. As far as I understood from posts on this forum (but this may be totally wrong)this due to the value of the STRIDE parameter in the Active View source. Would it be possible to play with this parameter without accessing to Labview?
Best,
LL