Saving bipolar channels

[obonsawin]

I may be missing something obvious here. I have started recording EMG, and can view the relevant bipolar channels on the bipolar tab. Unfortunately, I can't figure out how to save these bipolar channels. I only seem to be able to save the monopolar channels EX channels. I am sure I am not seeing something obvious on the Actiview screen. What am I missing?

Thank you
Marc

[Coen]

There are no separate bipolar hardware channels. The bipolar display is simple a referenced view of the EX channels. If you save the EX channels, then all is OK. You should of course calculate the bipolar leads again in you off-line review software (EX channel are saved in unreferenced monopolar form)

Best regards, Coen (BioSemi)

[obonsawin]

Thank you Coen.

Marc