How to send 16-bit event codes?

Post Reply
fmarini
Posts: 1
Joined: Fri Jan 27, 2017 11:28 pm

How to send 16-bit event codes?

Post by fmarini »

Hi Coen,

I am using the ActiveTwo system and would like to send 16-bit event codes. Is this possible at all?

My event code setup is the following:

Matlab --(USB)--> Cortech SD-MSTCPUA --(parallel/DB37F)--> Biosemi USB Reciver 5.1 --(USB)--> Recording PC (ActiView)

On the output side, I am able to open a 16-bit DAQ channel in Matlab and send out 16-bit binary codes. However on the input side (Actiview) my codes appear to be 8-bit only. Can you help finding a solution?

Thanks!

Francesco

---
Francesco Marini, Ph.D.
University of Nevada Reno
Dept. of Psychology

Coen
Site Admin
Posts: 1124
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands
Contact:

Re: How to send 16-bit event codes?

Post by Coen »

Measure the 16 trigger lines arriving at the BioSemi USB-receiver with a voltmeter.

Best regards, Coen (BioSemi)

Post Reply