Page 1 of 1

Ergo Response Switch

Posted: Sat May 07, 2016 4:59 pm
by cmmfong

I'm exploring to use the ERGO response switch in my experiment. However, I am not sure how I can send the responses of the subjects back to the experimental software I'm using (E-Prime). Any hints would be much appreciated.

Best regards,
CM Fong

Re: Ergo Response Switch

Posted: Mon May 09, 2016 1:23 pm
by Coen
Edit the 4th line of the CFG file to:


You should now see the action of the response switches as triggers 9 and 10 in ActiView. At the same time, the triggers are available as output triggers 1 and 2 (pins 17 and 18) of the triggers port on the USB-receiver.

Best regards, Coen (BioSemi)