Ergo Response Switch

Post Reply
Posts: 1
Joined: Sat May 07, 2016 4:52 pm

Ergo Response Switch

Post by cmmfong » Sat May 07, 2016 4:59 pm


I'm exploring to use the ERGO response switch in my experiment. However, I am not sure how I can send the responses of the subjects back to the experimental software I'm using (E-Prime). Any hints would be much appreciated.

Best regards,
CM Fong

Site Admin
Posts: 887
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands

Re: Ergo Response Switch

Post by Coen » Mon May 09, 2016 1:23 pm

Edit the 4th line of the CFG file to:


You should now see the action of the response switches as triggers 9 and 10 in ActiView. At the same time, the triggers are available as output triggers 1 and 2 (pins 17 and 18) of the triggers port on the USB-receiver.

Best regards, Coen (BioSemi)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest