Analog output?

Post Reply
Posts: 1
Joined: Thu Feb 04, 2016 10:58 am

Analog output?

Post by ctallonbaudry » Thu Feb 04, 2016 11:29 am

Is there a possibility to convert back the signal from at least one of the EX1-8 channels to get an analog output? I would like to do some real-time synchronization with a ms precision.
Using the TCP-IP / Matlab protocol for real-time could be an alternative but I doubt I can reach the required time precision with it.

Thanks for your feedback

Site Admin
Posts: 915
Joined: Fri Mar 26, 2004 7:00 pm
Location: Amsterdam, Netherlands

Re: Analog output?

Post by Coen » Thu Feb 04, 2016 4:15 pm

Analog output is not possible.

Consider using (BioSemi driver is now available), or work in LabVIEW with modified ActiView.

Best regards, Coen (BioSemi)

Post Reply