Trigger output for synchronization
Posted: Thu Feb 04, 2016 5:34 am
Hi,
I want to synchronize two different systems (EMG data from Biosemi and Torque sensor data) via Trigger signals. There is no need for real-time synchronization, that's why I want to get a trigger output signal whenever I "start" or "stop" data acquisition by the ActiView Software.
However, the only relevant information I could find on this website is the following:
"The trigger outputs can be controlled by software. ActiView Light (developer software) has a LabVIEW routine integrated which is able to control the trigger outputs."
And I saw that the Pins 17-31 of the USB-Receiver can provide Trigger outputs.
So far so good. Unfortunately, the trigger output is always 0V whenever I start or stop a file and I cannot find any information about how to actually get a trigger output, e.g. 3.3V or 5V.. What do I have to do? Is this even possible with my version of ActiView704 or do I need to get a specific other software?
Thanks for the help in advance!
Cheers,
Lukas
I want to synchronize two different systems (EMG data from Biosemi and Torque sensor data) via Trigger signals. There is no need for real-time synchronization, that's why I want to get a trigger output signal whenever I "start" or "stop" data acquisition by the ActiView Software.
However, the only relevant information I could find on this website is the following:
"The trigger outputs can be controlled by software. ActiView Light (developer software) has a LabVIEW routine integrated which is able to control the trigger outputs."
And I saw that the Pins 17-31 of the USB-Receiver can provide Trigger outputs.
So far so good. Unfortunately, the trigger output is always 0V whenever I start or stop a file and I cannot find any information about how to actually get a trigger output, e.g. 3.3V or 5V.. What do I have to do? Is this even possible with my version of ActiView704 or do I need to get a specific other software?
Thanks for the help in advance!
Cheers,
Lukas