I wonder if anybody has advise on how to get stimulus/response triggers generated by e-prime (sent out through a serial port) to the Biosemi EEG digitizing machine.
Is there a scheme available about how to build a connecting cable?
Thanks
Mario Liotti
Reader of Cognitive Neuroscience
Department of Psychiatry
University of Noyttingham
email: mario.liotti@nottingham.ac.uk
e-prime/serial port to digitizing computer
-
- Site Admin
- Posts: 1125
- Joined: Fri Mar 26, 2004 7:00 pm
- Location: Amsterdam, Netherlands
- Contact:
The connection of triggers to the ActiveTwo receiver is described on http://www.biosemi.com/faq/trigger_signals.htm
The pin layout of a cable for an interface with E-prime is found on http://www.biosemi.com/faq/presentation.htm
Best regards, Coen (BioSemi)
The pin layout of a cable for an interface with E-prime is found on http://www.biosemi.com/faq/presentation.htm
Best regards, Coen (BioSemi)
eprime triggers
We found we had to send a zero after sending an eprime trigger or subsequent triggers would sum. Hope this helps.